Cyclestat 4P Timer

The Cyclestat 4P repeat cycle timer has solved the age old problem of accurate short cycle timing. Perfect for plant zone environments, reptile habitats or any other application requiring automatic short cycle switching. No programming required. Easy to set and operate. Microprocessor time counter with adjustable frequency and duration. The Cyclestat 4P timer has many uses. Only a few of them include: fogging or misting, spray stakes or drip system timing, air pumps, CO2 equipment and intake or exhaust fan control. The Cyclestat may be set for interval and cycle of timed events. Interval is the time between the "On" and "Off" cycles. The interval knob may be set from 5 minutes to 8 hours. Set this for desired time between functions. Cycle is the length of time that a specific function or condition must be maintained. Cycle may be set from 5 seconds to 30 minutes.

Automatic reset feature allows function synchronizing with other system controls. Turn the switch off and on again for manual operation. The Cyclestat 4P has a built-in photosensor to defeat timing during darkness hours. Photosensor may be switched in or out as desired. Operates on 115 volts AC with 15 amp switching capacity. The Cyclestat 4P utilizes a duplex piggy-back power cord which provides a combination plug and receptacle design. Insert plug into 115V wall outlet and plug equipment into piggy back receptacle.

Cycle Timers

• Cycles at 4P - repeat cycle timer

• Easy to install and operate

• Microprocessor controlled, adjustable time counter

• Event time: 5 seconds to 30 minutes

• Interval time: 5 minutes to 8 hours

• Built-in light activated photo sensor with "on-off" switch puts you in control

• Fully integrable with other controls